Archive for the ‘pet projects’ Category

I got everything laced up cleanly and optimized the hell out of it, that’s about 1200 triangles worth of lacing in the end. Unfortunately there is no way around this.

I’ve also started packing my UVs and went for an “optimized” solution for the lacing texture ( 32×32 pixels 😛 ).

I really hope it will look right in the end.

Pretty much. I also would like to take some time to figure out if there is any chance to simplify the model further. 4500 triangles is still an awful lot.

I blame all those curved texture seams!

I was pretty much nodding off the entire evening yesterday so I pressed on until the main body was completely filled in.

I’m not sure if it looks any different from this angle…

I ment to do more today but I won’t have time to do much, so here is yesterday’s update that I forgot to post.

Again the center area is getting progressively better, and I did some work on the tongue and velcro straps, it’s getting there but it’s too slow!

I’ve also added a nice and comfy lining. Now it’s even thicker.

Soon enough this is going to turn into a ski boot 🙂 I hope not!

…and I don’t like it. It looks clumsy, the flow is bad, it’s too dense. But I guess it will do for now.

A brief gallery of the progress over the last two days. On the last picture I also adjusted the velcro straps to have longer ends.

I did some rebuilding in order to insert the side panels and the reenforcement strips around the grommets, I also added those and a lacing mockup.

The velcro straps are also 50% wider (I still have to redo those proper, these are also just mockups) and I added a small trim under the ankle padding.

That was a long break, I know, but I needed some rest.

And now for something completely different 🙂

This is a first draft of the design, I like what I’m seeing but I suspect that It isn’t going to stay as is.

Warning: Cats might have taken over.