Some progress!

Last night was surprisingly very hm… fruitful, i scraped the original mockup and ended up with a better result on my second attempt, keyhole, black lining, i even started working on the hasp system for the main lock.

This belt will use a ‘thong style’ rear, in the form of a plastic coated wire. I know a lot of you would prefer a single metal band going from back to front but this create just too much trouble for fitting it to avatars after.

I initially wanted to use a specialised lock but decided against it to make it more compatible with my system, and for the same reason, no shackle shroud on the padlock.

I am now pondering about how to attach the wire at the back of the belt and how many chaining rings it will have. I haven’t worked on the parts that aren’t symmetric yet, the little riveted plate will only protrude on the right  since it’s the connector piece that close the belt, i will also have to cut the belt on the right of the center piece to make a proper seam.

Lastly, I need to think about how to fit the secondary shield in there and an eventual dildo attachment 🙂

Leave a Reply

Kyrah Abattoir
Creator of BDSM and fetish content in Second Life since 2004.

Seasoned 3D artist and programmer, aspiring video game creator.

  • [—]2023
  • [+]2022
  • [+]2021
  • [+]2020
  • [+]2019
  • [+]2018
  • [+]2017
  • [+]2016
  • [+]2015
  • [+]2014
  • [+]2013
  • [+]2012
  • [+]2011
  • [+]2010
  • [+]2009
  • [+]2008
  • [+]2007
  • [+]2006